![]() T his setup does not require third-party DNS services such as DynDNS. Using 0.0.0.0/0 as the remote gateway is supported only for site-to-site tunnels in Aggressive mode. B ecause t he WAN IP address of Location 1 is chosen dynamically via DHCP, t he remote gateway on Location 2 must use 0.0.0.0/0 so that any incoming IP address is accepted. You will need to add an access rule to allow VPN traffic. ![]() In this setup, Location 1 acts as the active peer. To configure a Site-to-Site VPN connection between two Barracuda NextGen X-Series Firewalls, in which one unit (Location 1) has a dynamic Internet connection and the peer unit (Location 2) has a static public IP address, create an IPsec tunnel on both units.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |